In all cases electromagnetic disturbances must be reduced to the point where they are no longer troublesome.īefore installing the equipment the user shall make an assessment of potential electromagnetic problems in the surrounding area. In other cases it could involve constructing an electromagnetic screen enclosing the power source and the work complete with associated input filters. In some cases this remedial action may be as simple as earthing the cutting circuit, see Earthing of Workpiece. If electromagnetic disturbances are detected then it shall be the responsibility of the user to resolve the situation with the technical assistance of the manufacturer. The user is responsible for installing and using the plasma equipment according to the manufacturer’s instructions. This cutting equipment is designed for use only in an industrial environment. In such cases it may be necessary to use other measures to further reduce interference. The limits required by EN60974-10 may not be adequate to completely eliminate interference when the affected equipment is in close proximity or has a high degree of sensitivity. The equipment should be installed and used in accordance with the information below to achieve electromagnetic compatibility. Hypertherm’s CE-marked equipment is built in compliance with standard EN60974-10.

You can also receive updates on new Hypertherm products and a free gift as a token of our appreciation.Ġ0 800 49 73 7843 Tel (Technical Service)

Hyperterm free download